Kingfield Durotape Seaming and Detail Tape 4" x 50'

SKU: KFDUROTAPE.RL*NA
(0) No Reviews yet
$69.95

In Stock

Available: 242

Please order in multiples of 1

Rubber Comp. Seam/Detail Tape


High performance, double sided, modified butyl adhesive tape

Key Features


  • Compatible to multiple substrates
  • Aggressive, flexible, and malleable adhesive
  • Self-sealing around penetrations
  • Wide temperature application range
  • Barrier against water, vapor, and gas intrusion

Applications


  • Detailing tape for Hydrogel
  • Detailing tape for Pre-tak
  • Detailing tape for Penetrations
  • Adheres to metal, plastic, wood, gypsum, concrete, brick, and painted surfaces

The tape is an easy to use permanent sealing tape that bonds to most materials, including roofing membranes, metals, plastics, and most other materials. This detailing tape uses an elastomeric butyl adhesive bonded to a woven polyester fabric backing for maximum conformability. Versadex FB Fabric Tape can be used to seal leaking joints, seams, and cracks. It is designed to expand and contract without any cracking within normal roofing temperatures. Versadex FB Fabric Tape is not designed for direct exposure to UV but can be coated or painted with UV resistant coatings.

Recommended Uses


The tapes should be specified where a permanent seal is needed on the building envelope. Use the tape in conjunction with Kingfield waterproofing system materials. Fabric Tape may also be used as a detail material with other waterproofing and coating systems.

Substrate Compatibility


The tape will bond aggressively to most materials, including: metals, plastics, roofing materials, wood, gypsum, concrete, brick, fiberglass, and many previously painted surfaces. Perform adhesion test to confirm compatibility when required.

Surface Perpation


Surface must be clean and dry, with no oils, grease, or loose debris. Remove salt and other contaminants by pressure washing with a suitable non-solvent detergent followed by a fresh water rinse. Rust and other adhered foreign matter should be removed by scraping or wire brushing followed by a solvent wipe.

Application


Center the tape over the substrate removing the plastic release liner gradually to prevent contamination of the adhesive prior to application. This material may be applied to clean dry surfaces above 40°F. For exposed applications, a UV resistant coating should be applied over the tape to protect it from UV degradation. Topcoats can be applied directly to the fabric backing. Primer may be applied to the substrate surface to improve the adhesive bond.

Storage


Keep in dry storage out of direct heat and sunlight

Health & Safety


Consult SDS

Ratings & Reviews

No reviews available

Be the first to Write a Review