Mfr:Euclid Chemical

Euclid Hey'Di Powder X 30 Pound Pail

(0)(0)
Item #: EUHDIPOWX.30P*NA

Mfr. Part #: TR2122730

Q&A(0)

HEY'DI POWDER X is a combination of cementitious and silicate based materials used on negative side surfaces to seal and stop leakage caused by hydrostatic pressure. HEY’DI POWDER X SYSTEM is a 3 coat, two component system consisting of a powder and a liquid. HEY’DI POWDER X...

View More Details

On Back Order

Available: 0

Case Quantity: 5

Location

Available

Anaheim, CA

0

Burbank, CA

0

Denver, CO

0

Ontario, CA

0

Salt Lake City, UT

0

San Diego, CA

0

San Marcos, CA

0

(*) Minimum Quantity: 1

About This Product

Details

HEY'DI POWDER X is a combination of cementitious and silicate based materials used on negative side surfaces to seal and stop leakage caused by hydrostatic pressure. HEY’DI POWDER X SYSTEM is a 3 coat, two component system consisting of a powder and a liquid. HEY’DI POWDER X is a dry powder that hardens in seconds when exposed to water. HEY’DI SEALING LIQUID (ordered separately) penetrates through HEY’DI POWDER X into the capillaries of the substrate. It reacts with moisture and the constituents of the substrate to form crystals. While moisture is present, the crystallization process will continue for approximately six months. HEY’DI POWDER X SYSTEM is not designed to be used as a wearing surface. Horizontal surfaces subject to vehicle or heavy foot traffic must be covered with a protective topping.


Features & Benefits

  • Leaking and weeping concrete or masonry from the negative side
  • Protects against hydrostatic water pressure
  • Will not debond from the surface by water pressure

    Applications

    • Interior/exterior walls below grade
    • Slabs on grade and basements
    • Foundations
    • Reservoirs
    • Tunnels
    • Dry docks
     

    Packaging

    • Euclid Hey'Di Powder X 30 Pound Pail (this item)

    Limitations

    • HEY’DI POWDER X is a dark gray waterproofing compound and is not intended to be a decorative finish.
    • Do not apply to frozen or frost filled surfaces or when temperature is below 40 °F (4 °C) or expected to fall below 40 °F (4 °C) in 48 hours.
    • Do not apply in temperatures above 90 °F (32 °C).
    • Protect with a topping when used as a traffic wearing surface.
    • When applied to the inside of open cisterns, tanks, pools, etc., do not fill with water for at least 7 days after application. Ensure that adequate ventilation is available during the application and the full curing period when using HEY’DI POWDER X SYSTEM in enclosed tanks or reservoirs.
    • Allow minimum 7 days drying time before backfilling.
    • Allow 7 days cure before covering or before the application of a waterbased decorative coating.
    • Do not apply lime based products over HEY’DI POWDER X SYSTEM.
    • Do not substitute HEY’DI SEALING LIQUID.
    • Apply a test patch to evaluate performance and appearance on concrete or block substrates which have been subjected to contamination.
    • In all cases, consult the Safety Data Sheet before use.

    Documents

    HEY'DI POWDER X Documents

    Specifications

    HEY'DI POWDER X Specifications

    Q & A

    true
    Warning: This product contains a chemical known to the State of California to cause cancer.
    For more information go to www.p65warnings.ca.gov

    Ratings & Reviews

    No reviews available

    Be the first to Write a Review