- This power tool is intended to function as a grinder, sander, wire brush, polisher or cut-off tool. Read all safety warnings, instructions, illustrations and specifications provided with this power tool.
- Do not use accessories which are not specifically designed and recommended by the tool manufacturer.
- The rated speed of the accessory must be at least equal to the maximum speed marked on the power tool.
- The outside diameter and the thickness of your accessory must be within the capacity rating of your power tool.
- Threaded mounting of accessories must match the grinder spindle thread. For accessories mounted by flanges, the arbor hole of the accessory must fit the locating diameter of the flange.
- Do not use a damaged accessory. Before each use inspect the accessory such as abrasive wheels for chips and cracks, backing pad for cracks, tear or excess wear, wire brush for loose or cracked wires. If power tool or accessory is dropped, inspect for damage or install an undamaged accessory. After inspecting and installing an accessory, position yourself and bystanders away from the plane of the rotating accessory and run the power tool at maximum no-load speed for one minute.
| - Wear personal protective equipment. Depending on application, use face shield, safety goggles or safety glasses. As appropriate, wear dust mask, hearing protectors, gloves and workshop apron capable of stopping small abrasive or workpiece fragments.
- Keep bystanders a safe distance away from work area. Anyone entering the work area must wear personal protective equipment.
- Hold power tool by insulated gripping surfaces only, when performing an operation where the cutting accessory may contact hidden wiring or its own cord.
- Position the cord clear of the spinning accessory.
- Never lay the power tool down until the accessory has come to a complete stop.
- Do not run the power tool while carrying it at your side.
- Regularly clean the power tool’s air vents.
- Do not operate the power tool near flammable materials.
- Do not use accessories that require liquid coolants.
- When starting the tool with a new or replacement wheel, a new or replacement wire brush installed, or if you are unsure of the condition of the wheel, hold the tool in a well protected area and let it run for one minute.
|
Sign In / Register
My Lists
Contact Us
Tech Data Sheet