Mfr:Sika Corp
Sikalastic 736 AL Top Coat per 5 Gallon Pail
Mfr. Part #: -
Roll Over To Zoom
Sikalastic 736 AL Lo-VOC is a single component, aliphatic, moisture cured, low VOC, elastomeric polyurethane coating intended for use as the traffic bearing wear and top coat over polyurethane waterproofing membrane for pedestrian and vehicular traffic bearing applications....
View More DetailsAbout This Product
Details
Sikalastic 736 AL Lo-VOC is a single component, aliphatic, moisture cured, low VOC, elastomeric polyurethane coating intended for use as the traffic bearing wear and top coat over polyurethane waterproofing membrane for pedestrian and vehicular traffic bearing applications. Sikalastic 736 AL Lo-VOC can also be used as a high-performance decorative aggregate or vinyl flake embedment coat. Sikalastic 736 AL Lo-VOC provides superior UV resistance, color stability and cleanability, as well as more decorative options. Optional Sikalastic 700 ACL accelerator can be used to speed cure time.
- Superior color, gloss retention and cleanability
- Outstanding resistance to abrasion and wear
- Resistant to water and de-icing salts
- Alkaline resistant
- Range of standard colors, with custom colors and field-tintable tint base available
Usage
- Multi-story parking garages
- Parking decks and ramps
- Foot bridges and walkways
- Mechanical rooms
- Stadiums and arena
- Plaza and rooftop decks
- Balconies
Field Tintable Base
Add 6 Sikaflex® 2C pigment color packs to coating. Thoroughly mix coating using a mechanical mixer (Jiffy) at slow speed until a homogenous mixture and uniform color is obtained with no streaks (typically 3 minutes).
Use care not to allow the entrapment of air into the mixture. The use of 6 color packs per tint base unit provides 5 % pigment by volume, and is the standard recommended tint level.
Application
Apply at the recommended coverage rate using a notched squeegee or trowel, and backroll using a phenolic resin core roller. Apply aggregate evenly distributed at the appropriate rate immediately into wet coating and backroll if required. Allow coating to cure a minimum of 16 hours at 70 °F and 50 % RH or until tack free between coats. Allow coating to cure for a minimum of 72 hours before opening to vehicular or pedestrian traffic.
Q & A
For more information go to