Epro E.STOP HPL 16.67' Roll
Mfr. Part #: e.stop hpl
Roll Over To Zoom
e.stop hpl is a rubber based product that has been formulated with special hydrophilic compounds that are intended to expand in a controlled fashion when exposed to moisture.e.stop hpl is designed to self seal joints or penetrations in concrete when exposed to moisture, and ...View More Details
About This Product
e.stop hpl is a rubber based product that has been formulated with special hydrophilic compounds that are intended to expand in a controlled fashion when exposed to moisture.
e.stop hpl is designed to self seal joints or penetrations in concrete when exposed to moisture, and specified when a bentonite based waterstop is not effective due to contamination, or high salinity.
- Does not over expand which can cause self deterioration
- Does not over stress adjoining substrate material
- Excellent resistance in tidal areas (hydration/dehydration)
- Ideal for groundwater conditions that limit the effectiveness of bentonite based products
Firmly press the entire length of e.stop hpl onto the adhesive. For best results apply e.stop hpl within 30 minutes of adhesive installation. e.stop primer may be applied to damp surfaces, but not in standing water. At structural and pipe penetrations, cut into strips to fit around the penetration. Apply to adhesive and abut coil ends together. On irregular surfaces such as stone or rough concrete, make sure waterstop remains in direct contact with the substrate along the entire installation. There should not be any air gap between the waterstop and the substrate.
- 16.8' x 3/4" x 1" x per roll
- 16.8' linear feet
Q & A
For more information go to